Proceed PDP User Manual download pdf (Page 2)

Front panel

emphasis

select

source 1 source 2 source 3 source 4

standby

4 3

1 2

sampling frequency

1 standby

When the master power switch on the rear panel is in the "|" (on)

position, pressing this button takes the PDP 3 out of “standby”

mode, turns the Display on, and makes the processor ready to

operate. (See “Rear panel” and “Set-up and installation.”)

2 Standby LED

This LED lights when the PDP 3 is in the standby mode.

3 sampling frequency Display

This Display shows the sampling frequency (expressed in kHz) for

the digital source you selected.

For digital FM, the Display will show 32; for compact disc digital

audio, the Display will show 44; for pre-recorded digital audio

tape, the Display will show 48. If no valid digital source is selected,

or if the selected source is inactive, the Display will show - - .

4 source LEDs

These LEDs light corresponding to the selected digital source.

5 select

Pressing this button selects the digital source, according to the

input connections on the rear panel. (See “Rear panel” and “Set-

up and installation.”)

Only one source at a time may be selected.

When the PDP 3 is taken out of the standby mode, the source last

selected before going into standby will be automatically selected

and the LED above that source will light; for example, source 1.

Pressing the select button at this point would select source 2;

pressing it again would select source 3, and so on. Pressing select

when source 4 is selected again selects source 1.

1 2 3 4 5 6 7 ... 19 20

No comments

Proceed PDP User Manual Page 2