Proceed PDP User Manual download pdf (Page 8)

You may choose instead to install the spikes in a triangular

arrangement:

Install the spikes one at a time.

Using the supplied hex key, remove

the screw securing the foot to the base of the unit. Insert the

threaded end of the spike through the hole in the foot, then turn it

clockwise until it’s hand-tight. (Be careful not to over-tighten it.)

Repeat this procedure for each spike you install.

4. Turn the PDP 3 upright, and place it in the desired location.

The PDP 3 should be located on a level, stable surface. Avoid

placing it where it will be exposed to shocks or vibration (such as

on an unstable table or near large loudspeakers). For best

performance, locate the PDP 3 away from tuners, televisions, and

other sources of radio frequencies.

DON'T place the PDP 3 on top of another component, since its

base could block the other component’s ventilation. Interfering

with the PDP 3’s ventilation or that of another component could

cause either to overheat, resulting in damage to your system.

Make sure that power is turned off to both the PDP 3 and your

receiver, integrated amplifier, or preamplifier/power amplifier.

■ The quality of the cables and connectors that you use with your

Proceed PDP 3 can noticeably affect the quality of the sound

that you hear from your speakers or headphones. For the best

performance, use the highest quality audio cables available.

Though there are many such cables to choose from, we

confidently recommend Madrigal HPC cables (for analog

signals) and Madrigal MDC (for electrical digital signals). See

your Proceed dealer for more information.

Three spikes,

mounted in a

triangular pattern

PRECAUTION

A word about cables

Location

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Proceed PDP User Manual Page 8